Hanna Groline – Cleaning Solution For PH Electrodes – 120ml (HI-7061-012)

Hanna’s cleaning solutions eliminate impurities and residues that are left on electrode surfaces when immersed in samples during measurement or when stored incorrectly.

Cleaning is a fast and effective routine that should be performed on a regular basis as a preventative measure against using a dirty electrode and to ensure that the junction is not clogged. By simply immersing the electrode in the HI-7061-012 cleaning solution for 15 to 20 minutes will dissolve any mineral deposits or other coatings.

Electrodes can become dirty from use and will produce inaccurate results even if they read correctly in a pH buffer.

The most common cause for pH measurement inaccuracies is an unclean or improperly cleaned electrode. This is very important to note because, during calibration, the instrument assumes that the electrode is clean and that the standardisation curve created during the calibration process will remain a valid reference until the next calibration.

pH meters on the market today will allow an offset voltage of approximately ±60 mV. The deviation from 0 mV is not unusual but ideally should be no greater than ±30 mV. The calibration process compensates for the change in offset voltage. If the mV offset continues to deviate and the meter is calibrated with a dirty electrode then inaccurate readings will result.

Other Hanna Groline Products

• Cleaning Solution
• Quick Calibration for pH and EC
• Storage pH Solution
• 98115 pH Meter
• 98118 pH/Temperature Meter
• 98318 EC/TDS/Temperature Meter
• 9814 pH/EC/TDS Meter
• 981420 pH/EC/Temperature Meter